130x35x1100 ITA/FEM/ISO Forks
Load center : 500mm
Weight of single fork: 53kg
Mounting class :2A
The weight of a single 130x35x1100 ITA/FEM/ISO fork is 53 kg. The cross-section is 130 mm wide, 35 mm thick, and one meter long. There is a high-precision level bubble and angle dial embedded at the root of each fork. The operator can directly read the left and right side tilt angle of the forklift hanging plate with an accuracy of 0.5 degrees, and make timely adjustments to avoid unbalanced loading. Four replaceable carbide conical teeth are installed under the fork tip. The tooth tips protrude 1.5 mm from the fork surface. They are specially used to scoop up heavy-duty fiberboard or rubber pads that are close to the ground. When worn, the old teeth can be unscrewed and replaced with new ones. The inside of the hook is equipped with a double row of needle roller bearings. When pushing the hanging plate, rolling friction replaces sliding friction, making installation labor-saving and positioning accurate. The product meets the three major standards of ITA, FEM and ISO at the same time. The lower hook bearing surface is embedded with self-lubricating graphite pillars and requires no oil filling for life. The fork surface is processed with a spiral guide groove with a depth of 0.5 mm.
When pushing wet goods, accumulated water is quickly discharged to both sides along the spiral line to avoid slippage caused by water film adsorption. During the integral casting, a copper conductor running through the length of the fork is pre-embedded and connected to the forklift grounding system, which can safely conduct away the static electricity generated when handling chemical fiber raw materials or plastic particles. The surface treatment uses orange epoxy powder coating, which is bright and eye-catching. Before each pair of forks leaves the factory, a level calibration and fork tine alignment test is performed on the entire length of 1,100 mm. With a single weight of 53kg and the double anti-slip handles on the back of the fork, a single person can lift it and put it into the hanging board horizontally. This specification mainly serves large fiberboard warehouses, rubber product workshops, and static-sensitive electronic packaging material yards.






Hot Tags: 130x35x1100 ita/fem/iso forks, China 130x35x1100 ita/fem/iso forks manufacturers, suppliers, factory, Forklift truck forks, Pallet Fork Tines, Forklift Replacement Fork, ITA Class V Forklift Forks, Clamp on Universal Pallet Forks, Standard forklift Forks
You Might Also Like
Send Inquiry














