130x35x1000 ITA/FEM/ISO Forks
video

130x35x1000 ITA/FEM/ISO Forks

Capacity of fork couple: 2500kg
Load center : 500mm
Weight of single fork: 49kg
Mounting class :2A
Send Inquiry
Product Introduction

The 130x35x1000 ITA/FEM/ISO fork has a single weight of 49 kg, a paired rated load capacity of 2500 kg, a load center of 500 mm, and an installation level of 2A. The cross-section is 130 mm wide and only 35 mm thick, forming a wide flat fork surface, specially used for handling large-sized but low-density long boards, glass wool rolls or foam ceramic products. The back of each fork is milled with a stress-unloading groove of gradually varying depths along the entire length, which guides and disperses the peak bending stress toward the fork tip, avoiding premature root fatigue common for ultra-long and thin-section forks. The hook locking device adopts a centrifugal-triggered pawl. When the forklift travels at a speed exceeding 8 kilometers per hour, the pawl automatically opens and presses the lower edge of the hanging plate to prevent lateral slippage caused by driving vibration. After parking, the pawl contracts to facilitate disassembly. The upper surface of the fork tip is vacuum-clad with a layer of chromium carbide wear-resistant tape, and a three-stage wear indicator step is ground and processed.

 

 

After the first step is ground, monthly inspections are prompted, after the second step is ground, it is recommended to use it with reduced load, and after the third step is ground, it is scrapped immediately. The product meets the three major standards of ITA, FEM and ISO at the same time. The inside of the lower hook is pre-installed with a self-lubricating composite bushing, which is maintenance-free. The surface treatment adopts high weather-resistant polyurethane topcoat, and the color is international orange, which is very eye-catching in the yard. Before each pair of forks leaves the factory, they are elastically restored under a full load of 2,500 kilograms, and the height difference between the left and right forks does not exceed 0.3 mm. With a single weight of 49 kg and a foldable roller cart at the end of the fork, one person can push it to the hanging plate opening and use the lever principle to push and lock it smoothly. This specification is commonly found in large rock wool board production lines, the discharge end of fiberglass curing furnaces, and prefabricated building wall panel yards.

 

 

 

production 1001

quality 2001

 

packaing 4

packing 4

performance 3

CE 5

 

 

 

 

 

 

 

Hot Tags: 130x35x1000 ita/fem/iso forks, China 130x35x1000 ita/fem/iso forks manufacturers, suppliers, factory, Heavy Duty Pallet Forks, Lift Truck Forks, Forklift Fork blades, FEM Forks, Clamp on Universal Pallet Forks, Forklift carne arms

Send Inquiry

whatsapp

Phone

E-mail

Inquiry