100x45x2100 Blank Forks

100x45x2100 Blank Forks weigh 89kg each. The cross-section is 100 mm wide, 45 mm thick, and two meters long. This blank fork is specially designed for emergency repairs and on-site modifications in the field. The fork surface uses laser cladding technology to directly print out a 1:1 ratio of common hanging plate templates, including hook outlines, positioning hole center distances and locking groove shapes. Users only need to carry a portable magnetic drill and angle grinder to process according to the drawings, without the need to measure and draw lines. Each 89-kg billet is made of sulfur-containing free-cutting steel 38MnVS, with the sulfur content increased to 0.08%. It has excellent chip breaking performance, does not stick to the knife when drilling on site, and doubles the efficiency. The fork tip is pre-cut with a 30-degree wedge-shaped guide surface, which can be directly used for temporary shoveling operations.

 

 

There is no QR code or engraving on the fork surface, only the material and furnace number are marked with steel stamps on both ends. The surface is coated with a thick film of water-based anti-rust wax and will not rust if stored in the open air for two years. The packaging uses an expandable folding steel frame. After unfolding, the forks are fixed horizontally, making it convenient for users to drill or cut directly on the frame. With a single weight of 89 kg and three M16 process screw holes on the back of the fork, manual lifting chains or forklifts can be used to assist loading and unloading. This specification is mainly intended for self-provided maintenance units at overseas engineering sites, mine rescue teams, and field exploration camps, and is used as raw material for emergency replacement of old equipment forks.

 

 

 

 

 

 

 

 

 

 

 

 

 

Hot Tags: 100x45x2100 blank forks, China 100x45x2100 blank forks manufacturers, suppliers, factory