100x45x1900 Blank Forks

100x45x1900 Blank Forks weigh 82kg each. The cross-section is 100 mm wide, 45 mm thick, and the total length is 1.9 meters. This blank is directly hammered into shape using the free forging process. The original forging black leather and hammer marks are retained on the surface. It has not undergone any fine straightening or mechanical processing, allowing a natural bending of 1.5 mm per meter. Users can use flame heating to correct themselves according to on-site needs, or directly use it to make disposable tooling, temporary spreaders and welding bases for heavy equipment. Each 82kg billet is made of ordinary Q355B and does not guarantee low-temperature impact performance, but each batch comes with a chemical composition re-inspection sheet and room temperature tensile data. The fork tip is flat and right-angled without any chamfering, and users can cut it into any shape by themselves.

 

 

The fork surface does not have any reference lines, QR codes or positioning marks, and remains completely as forged. The surface is coated with a cheap peelable asphalt anti-rust layer, suitable for open-air stacking. The packaging is bundled with simple steel straps, and each group of three is separated by wooden squares. The single weight of 82 kg allows two workers to use steel pipes to pass through the process pits on the back of the fork to lift them directly without the need for special spreaders. This specification is mainly intended for small machinery maintenance shops, construction sites and temporary mine maintenance points. It is used as a replacement blank for homemade fork hooks, bulldozer tooth reinforcement plates or heavy machinery bases. It is not recommended for precision machining or load-bearing certification occasions.

 

 

 

 

 

 

 

 

 

 

 

 

 

Hot Tags: 100x45x1900 blank forks, China 100x45x1900 blank forks manufacturers, suppliers, factory