120x40x1900 ITA/FEM/ISO Forks
video

120x40x1900 ITA/FEM/ISO Forks

Capacity of fork couple: 3000kg
Load center : 500mm
Weight of single fork: 81kg
Mounting class :2A
Send Inquiry
Product Introduction

The weight of a single 120x40x1900 ITA/FEM/ISO fork is 81 kg. The cross-section is 120 mm wide, 40 mm thick, and the total length is 1.9 meters. This pair of forks uses a bionic shark skin micro-grooved surface with a groove depth of 0.1 mm and a spacing of 0.3 mm. The grooves are arranged parallel along the length of the fork. When pushing wet or sticky goods, the resistance is reduced by about 30%. It also has a self-cleaning function. Water and oil stains are quickly discharged from the fork surface along the grooves. The fork tip is equipped with a replaceable polycrystalline diamond composite sheet with a hardness of up to 10,000HV, which is specially used to remove solidified cement residue or resin lamination. After the composite sheet is worn, loosen the wedge-shaped pressing block and replace it with a new one. The contact surface between the hook and the hanging plate is processed into an alternating convex wave shape, which relies on elastic deformation to achieve multi-contact locking without any bolts or lock pins. When disassembling, just step on the release pedal. The product meets the three major standards of ITA, FEM and ISO at the same time.

 

 

The inside of the lower hook is pre-installed with graphite inserts and requires no lubrication for life. A V-shaped guide groove with gradual depth is pressed along the axis in the middle of the fork surface, with the bottom of the groove pointing toward the fork tip. When pushing the tray of scattered powder, the powder slides along the groove to prevent accumulation and jamming. Vacuum isothermal quenching is used for heat treatment to obtain a carbide-free bainite structure and increase the impact toughness by 50%. Before each pair of forks leaves the factory, the friction coefficient of the bionic surface of the entire length of 1.9 meters is measured and engraved on the fork legs. The surface is coated with a transparent diamond-like carbon film, which is wear-resistant and does not change the metal color. The unit weight of 81 kg is combined with the hydraulic buffer ejector built into the end of the fork. By rotating the valve, the fork can be raised to the height of the hanging plate, and one person can complete the replacement. This specification is specially used for the demoulding of cement prefabricated parts, the grouting table of resin handicrafts, and the transfer of rubber pallets of large rubber internal mixers.

 

 

 

production 1001

quality 2001

 

packaing 4

packing 4

performance 3

CE 5

 

 

 

 

 

 

 

 

 

 

Hot Tags: 120x40x1900 ita/fem/iso forks, China 120x40x1900 ita/fem/iso forks manufacturers, suppliers, factory, ITA Class V Forklift Forks, Forklift Fork blades, Forklift carne arms, Pallet Forks Attachment, Forklift Replacement Tines, Pallet Fork Tines

Send Inquiry

whatsapp

Phone

E-mail

Inquiry